Tech-MCT Compact/Tall Tool Bag
VPP10060
Compact, Yet Fully Featured Service, Repair or Install Tool Bag

PRODUCT SPECIFICATIONS:
Height (H) : 14” (35.5cm)
Width (W): 12" (30.5cm)
Depth: 8.5" (21.5cm)
Handle Height (HH): 17" (43cm)
Weight (empty):  5lbs/2.25 kg
Internal Volume: 800in3/13L
Max Payload: 30lbs/14kg

MAXIMIZED TOOL STORAGE CAPACITY:
Vertical Tool Pockets: 44 interior and exterior tool pockets of various sizes
2 Storage Bays- Hand Tools on one side; Meter and Drill Storage on the other side
2 Neoprene Pockets on Meter Side
D-Rings: 2- 2" and 5- 1"
Outside Mounted Stainless Steel Tape Clip Holder
Quick Access Pocket for Drill Bit Extensions and Small Items
YKK ® Zippers

RUGGED MATERIALS & CONSTRUCTION:
Weatherproof Base: 3mm Injection Molded Polypropylene
Weatherproof Body Fabric: 1200 PVC Impregnated Denier Nylon
Weatherproof Tool Pocket Fabric: 1800 PVC Impregnated Denier Nylon
8" Electrical Tape Strap
Over-Molded Ergonomic Grip
Can Hold over 50 Tools
Over-Molded Ergonomic Grip
5 Year Manufacturer Defect Warranty
Zippers: YKK ® Zippers
D-Rings: Powder Coated Steel
Rivets: Marine Grade Rivets

Additional Information
VETO PRO PAC TOOL BAGS PRODUCT CARE AND MAINTENANCE

• Keep the Zippers Clean & Lubricated
• Over time, dirt and grit will “clog” the zipper coils preventing them from staying closed. To keep this from happening, clean and lubricate your zippers twice a year (more often if you work on a job site with a high amount of airborne debris). To clean the coils: Scrub them with soapy water; a tooth brush works very well. After scrubbing the coils, blow them out with an air hose to dislodge any other fine grit that didn’t dislodge with the brush. To lubricate the coils: Apply a silicone spray, beeswax or a zipper lubricant.
• Protect the Zippers From Sharp Objects and/or Excessive Heat
• Any sharp object or heat source is capable of permanently damaging the zippers. Once a zipper coil is cut or singed the zipper will not function and in most cases is not repairable. Most of the cut zipper coils we see are the result of sharp tools stored inside the bag with the sharp side facing up. Make sure to keep the sharp edges of your tools facing down in your bag and away from the zipper coils.
• Don’t Overstuff the Bag
• Overstuffing your tool bag will very likely cause significant stress on the zippers that is above and beyond what the bag was built for and will eventually cause the zipper(s) to separate. If you have to work hard to close your zipper(s), your tool bag is most likely overstuffed… proceed with caution!